ONLY FOR EXPERTS::
hi all.,
if u using reliance wi-max then check this out.,

1]

go to .,
start > control panel > network connections > then goto properties of the local area connection (ur lan card properties) > click on internet protocol (tcp/ip) > properties > and set the static ip 192.168.1.22 in use the following ip address dialog box.


2]

now start ur lan connection ., by right click on it and select enable.


3]

now go to
start > run > cmd [press ok]

4]

now type there
c:\> telnet 192.168.1.1 if it fails then telnet 192.168.0.1

now u should have shell .,

asking for
username and password.,
enter
username : support
password : support


5]

now u have access to the wimax antenna via telnet then type

sh bs[hit enter]

it will show u something useful data.



like signal strength and frequency.,

so move ur antenna if u getting weak signal slightly.,
and again type

sh bs

u will notice some changes their., do this procedure till u get high signal.,

each time u move ur antenna give again command sh bs [enter]

tell me what happens .,at ur side.,

also after all this done again set all to ur original conditions.


-------------------------------------------------------------------
first create restore point of ur windows so., if anything goes wrong u can recover it., urself ., instead off calling the dumb guys at their cc.